Spektrum DX18 Instrukcja Obsługi Pobierz pdf (Strona 10)

10 SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL

You establish failsafe positions when you bind your transmitter

and receiver. If the radio signal connection is lost between the

transmitter and receiver, the receiver immediately moves the

aircraft control surfaces to the failsafe positions. If you assign the

receiver THRO channel to a transmitter channel other than throttle,

we recommend using Preset failsafe with the throttle in the low

position.

NOTICE: Failsafe features vary according to receiver. Always

consult the receiver instruction manual for failsafe features.

Before  ight, ALWAYS con rm the failsafe functions as you would

expect.

SmartSafe

Failsafe

SmartSafe failsafe is a technology that only acts on the throttle

channel and offers the following bene ts:

• Prevents electric motors from operating when the receiver

power is on and the transmitter power is off.

• Prevents the speed controller from arming until the throttle is

moved to the low throttle position.

• Powers off an electric motor and reduces gas/glow engines to

idle if signal is lost.

To Program SmartSafe, move the throttle to the low or off position

before putting the transmitter into bind mode.

To Test the SmartSafe failsafe

1. Power the transmitter and receiver on.

2. Power off the transmitter. The throttle should immediately move

to the failsafe position.

CAUTION: Make sure the aircraft is fully restrained on

the ground. If the failsafe is not set correctly, your aircraft

might advance to mid or full throttle.

Hold Last Command

The Hold Last Command failsafe maintains the last command on

all channels except throttle. If the radio signal is lost, the aircraft

maintains the commanded heading until the receiver regains

signal.

To program Hold Last Command, follow the provided binding

instructions in this instruction manual.

To Test Hold Last Command:

1. Power on the transmitter and receiver.

2. Move one of the control sticks to the desired Hold Last

Command position and hold the input.

3. While holding the control input (for example, a small amount of

rudder) power off the transmitter. The rudder should maintain

the input command.

CAUTION: Make sure the aircraft is fully restrained on

the ground. If the failsafe is not set correctly, the aircraft

throttle might advance to mid or full throttle.

Preset Failsafe

The Preset failsafe moves all channels to their programmed

failsafe positions.

We recommend using Preset failsafe to deploy spoilers on sail-

planes to prevent a  yaway if the radio signal is lost.

To program Preset failsafe:

1. Insert the bind plug in the bind port on the receiver and power

on the receiver.

2. Remove the bind plug when the orange LED on the main

receiver and all attached remote receivers  ash rapidly. The

orange receiver LEDs will continue  ashing.

3. Move the transmitter control sticks and switches to the desired

Preset failsafe position. Power the transmitter on.

4. Failsafe programming is complete when the orange LEDs on

the transmitter and all receivers turn solid.

CAUTION: Make sure the aircraft is fully restrained on

the ground. If the failsafe is not set correctly, the aircraft

throttle might advance to mid or full throttle.

PROGRAMMING FAILSAFE POSITIONS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 46 47

Komentarze do niniejszej Instrukcji

Brak uwag

Spektrum DX18 Instrukcja Obsługi Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Zdalne sterowanie Spektrum DX18